How to do the Taillight Mod
Materials Needed

2 cans of Gloss Black Paint
1 can of clear coat
1-2 rolls of Masking tape
Some sort of design you want to use
About 2-3 hours of time



1. Find a shape that you want to use.In this case I used Microsoft Paint and made a 7.5" x 5.5" Oval.

2.Lay down 6-8 strips of the wide masking tape on a table, making sure that the strips overlapped a little and then traced the shape on to them.

3.Cut out your shapes, placed them sticky side down on the light where ypu want them.

4.I used about 8 very light coats of Gloss Black Engine Enamel Paint.

5.Once it dries peel off the masking tape and then applied 3-4 coats of clear coat to the whole light. Wala Done.

One Note:

My lights are all red thoguh b.c I sprayed them with Testors Candy Apple Red Transparent Model paint first. Otherwise yours would have the clear part still.